FAQs
Where is it suitable?
Are the RGB strips energy efficient?
The lighting works best when the LED strip is positioned in a recessed location such that the light is reflected off a nearby surface. The colour of the nearby surface and its distance from the LED strip greatly influence the the intensity of light produced.
Is the lighting easy to install?
Yes - our 5m 60 LED/m RGB strips consume 48W full-on bright white, 20W for typical usage, and 2.5W in standby mode. Our 5m 30 LED/m RGB strips consume 32W, 14W & 2.5W respectively.
Yes - the flexible lighting strip has a self-adhesive backing and can easily be bent around corners with care. The strip can be cut to the required length using a sharp knife at the cut-points, which are every 5cm for the 60/m strips and every 10cm for the 30/m strips. Our kits come complete with everything you need to get going, including comprehensive installation and operating instructions.
How much LED strip will I need for my TV backlighting?
Asssuming that the strip is attached around all 4 sides on the rear cover, the approximate requirements are: 40"TV=3.1m, 42"TV=3.3m, 50"TV=3.75m, 55"TV=4.2m, 60"TV=4.6m, 65" TV=5.0m.
I need more than 5m of LED strip - what else do I need to buy?
To establish what components are needed in larger installations, click on the Technical link in the left column.
Our Best Buys
Follow Us
LED mood lighting specialists
I have some left over LED strip - is it possible to use it?
Yes. To find out how to use strip remnants, click on the Technical link in the left column.
Can this type of lighting be powered by a lighting circuit?
Yes, however a light dimmer is not a suitable feed, a light switch is suitable.
20 pre-defined colours
6 memories
Remote control (IR)
Colour jump/fade modes
6 memories
Remote control (IR)
Colour jump/fade modes
In-built Mic & ext line in
7 static colours
Remote control (RF)
Colour jump/fade modes
7 static colours
Remote control (RF)
Colour jump/fade modes
1500-colour kit 5m strip
Touch control pad
32 static colours
Remote control (RF)
Colour jump/fade modes
32 static colours
Remote control (RF)
Colour jump/fade modes
Touch sensitive kit 5m strip
New to mood lighting?
Sound sensitive kit 5m strip
Which RGB strip do I need - 30 LED/m or 60 LED/m?
In most cases, the 30 LED/m strips are quite sufficient - especially when the reflecting surface is white or pale, and the distance between the LED strip and the surface is between 5-30cm. For darker reflecting surfaces, for heavily patterned (e.g. wall-papered) surfaces, and in situations where the surface is less than 3cm from the strip (e.g LED TV backlighting using a close-mount bracket), then our 60 LED/m strips may be more suitable.
Starter kit-easy assemble
5m strip, remote control
16 colours + fade +jump
5m strip, remote control
16 colours + fade +jump
+44 (0)7780 662082
Only £49
From £59
From £69
From £79